Please wait ....



Syncronizing with fortnox

GUIDE TO CHANGE...

- GUIDE TO CHANGE BLOCK TEMPERATURE SENSOR (BLOCK NTC) ON HIPSTER KOBRA / WALL / UC

ESTIMATED WORKING TIME 15 minutes.
TOOLS NEEDED Allen key (Hex key) 2.5 mm..
NOTE 1 The block temperature sensors are close to the mains. DO NOT WORK ON THE SENSORS WHEN THE POWERCORD IS CONNECTED TO THE HIPSTER.
NOTE 2 All HIPSTER brewers have two block temperature sensors, one on each block. Make sure correct sensor is exchanged.

STEP 1

IMPORTATNT ALWAYS REMOVE POWER BY UNPLUGGING THE POWER OUTLET BEFORE DOING ANY SERVICE ON ANY HIPSTER BREWER

STEP 2.

REMOVE THE WATER CONNECTION

STEP 3.

OPEN THE HEATCASE

STEP 4.

REMOVE BLOCK TEMPERATURE SENSOR
NOTE TAKE CAUTIONS! The block temperature sensors and heatingelement may be hot, be carefull to check the temperature of the NTC prior to changing the sensor.

STEP 5.

INSERT BLOCK TEMPERATURE SENSOR
NOTE TAKE CAUTIONS! The block temperature sensors and heatingelement may be hot, be carefull to check the temperature of the NTC prior to changing the sensor.

STEP 6.

CLOSE THE HEATCASE
Dont forget to reinsert the insulation plate

STEP 7.

REATTACH WATER PIPES, TURN ON THE WATER

STEP 8.

RECONNECT THE POWER TO THE BREWER, TURN ON THE BREWER