- GUIDE TO CHANGE BLOCK TEMPERATURE SENSOR (BLOCK NTC) ON HIPSTER PULS
ESTIMATED WORKING TIME 15 minutes.
TOOLS NEEDED Allen key (Hex key) 2.5 mm..
TOOLS NEEDED Allen key (Hex key) 2.5 mm..
NOTE 1 The block temperature sensors are close to the mains. DO NOT WORK ON THE SENSORS WHEN THE POWERCORD IS CONNECTED TO THE HIPSTER.
NOTE 2 TAKE CAUTIONS! The block temperature sensors and heatingelement may be hot, be carefull to check the temperature of the NTC prior to changing the sensor.
NOTE All HIPSTER brewers have two temperature sensors, one on each block. Make sure correct sensor is exchanged.
STEP 1
IMPORTATNT ALWAYS REMOVE POWER BY UNPLUGGING THE POWER OUTLET BEFORE DOING ANY SERVICE ON ANY HIPSTER BREWERSTEP 2.
REMOVE THE UPPER BACK COVERSTEP 3.
REPLACE BLOCK TEMPERATURE SENSOR NOTE 1 TAKE CAUTIONS! The block temperature sensors and heatingelement may be hot, be carefull to check the temperature of the NTC prior to changing the sensor.
"